| |
Expert
Posts: 2965
| For the back, you can use whats there, cut off the hose from the metal
connection pipe at the can, this bit will have the valve on, tap a thread
into the end of the pipe, (3 or 4mm), loctite a bolt or grubscrew into the end,
job done for the back.
For the front, get a pair of MGF front hydro pipes with the valves in, these units
are screwed to the hydro pipes at the front of the car,
where they are screwed into the pipes, cut the nut off.
you have a nice bit of pipe to tap and bolt/ seal and have a valve for the front.
I've done a few now and its p#ss to do.
Dave C. | |
|