Viewing a thread

You are logged in as a guest. ( logon | register )

Vvc cam Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page]
Technical Area-> Technical	Message format

red1.1

Posted 21/2/2017 1:07 PM (#723301)
Subject: Vvc cam

Veteran

Posts: 412
100

Location: south east london

Hi sure I see it on here but any way I want to port polish a mg zs 1.8 solid cams also going to increase port size to as big as I can
That's not a problem can do all that will two vvc exhaust cams work in this engine heard some where the similar or the same as Kent cams and vvc inlet and injection any info would be grate just want to make my car the best it can be for as cheap as can be have all parts just need to know if it help the car already done bigger throttle body

red1.1

Posted 25/2/2017 9:18 PM (#723328 - in reply to #723301)
Subject: RE: Vvc cam

Veteran

Posts: 412
100

Location: south east london

Right found the post after some searching vvc cam in inlet is ok give the same power output as the 135 cam nearly the same by a fraction but give same output so that's happening cheap have vvc inlet going to port cylinder head to same size as inlet one last problem I'v heard that it could run lean cos of the 120 ecu setting could I get round this by using say vvc145 injectors or 160 I'm just trying to have a bit of fun with what I'v got any thoughts would be grate

Jump to page : 1
Now viewing page 1 [25 messages per page]

Printer friendly version
E-mail a link to this thread
Jump to forum :

(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software