Viewing a thread

You are logged in as a guest. ( logon | register )

Fzr 1000 carbs and 143 vvc INFO Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page]
Technical Area-> Technical	Message format

OGHAlex

Posted 10/6/2016 12:58 PM (#722206)
Subject: Fzr 1000 carbs and 143 vvc INFO

New user

Posts: 6

Hello.

I have a 143 mems 2 vvc Sat in my garage to go into my r100.
And I also have a nice set of fzr 1000 carbs that I managed to acquire a while ago.

What do I do in terms of wiring to run bike carbs?

I plan (if I do commit) to run solid cams and a dizzy, get myself an inlet for the carbs and run I believe what they call a 'fly by wire' set up??

But what exactly do I need to remove or install when it comes to sensors, OR ENGINE HARNESS IN GENERAL??
What do I do regarding the oxygen sensor, oil pressure sensor, crank sensor etc or do I literally just bolt the engine in with carbs and dizzy on, connect the dizzy up to coil, plumb the carbs in and it'll run?

Or am I missing something?

I'll have to get a fuel regulator for the carbs as they're low pressure but that's no big deal

Any help appreciated.
Thanks

MettyMatty

Posted 11/6/2016 8:32 PM (#722216 - in reply to #722206)
Subject: RE: Fzr 1000 carbs and 143 vvc INFO

Regular

Posts: 254
100

Location: Isle of Wight

I'm not sure if there's a way of using the MEMS Ecu with bike carbs but I would imagine Emerald would be able to offer a solution as they cater for throttle bodies bit this option will be ££'s

Alternatively there's the DIY option of using a Megasuirt ecu (no its not porn

)
This is cheaper but will take a lot of time to set up and map it correctly although you may get lucky and find a base map for a Rover K on bike carbs.

Jump to page : 1
Now viewing page 1 [25 messages per page]

Printer friendly version
E-mail a link to this thread
Jump to forum :

(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software