Viewing a thread

You are logged in as a guest. ( logon | register )

fly wheel Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page]
Technical Area-> Technical	Message format

gee2er

Posted 5/7/2016 5:13 PM (#722349)
Subject: fly wheel

Veteran

Posts: 435
100

Location: birmingham drives purple R100

hi all I'm going to put a 143 vvc into my 1.1 r100 this month I have the engine a loom ecu 5as I know my 1.1 fly wheel is no good and that I need a 1.6 one with a 200mm clutch I have a mems 3 1.6 fly wheel and clutch will this work or do I need one from a 216 416? I have access to a mgf pg1 and a zr 160 pg1 box I have a set of mgf shafts so could go pg1 but never put a pg in a tro b4 always run my r65 box on the 1.8 120 I have had b4 what would I need to go pg

Dave 20VTRO

Posted 8/7/2016 2:36 PM (#722364 - in reply to #722349)
Subject: RE: fly wheel

Elite Veteran

Posts: 925
500

Location: Thinking of vvc'ing my Roadster Brabus :-)

gee2er - 6/7/2016 4:13 PM

hi all I'm going to put a 143 vvc into my 1.1 r100 this month I have the engine a loom ecu 5as I know my 1.1 fly wheel is no good and that I need a 1.6 one with a 200mm clutch I have a mems 3 1.6 fly wheel and clutch will this work or do I need one from a 216 416? I have access to a mgf pg1 and a zr 160 pg1 box I have a set of mgf shafts so could go pg1 but never put a pg in a tro b4 always run my r65 box on the 1.8 120 I have had b4 what would I need to go pg

Mems 3 1.6 flywheel will be fine as sensor pattern on back of flywheel will be the same as the PG1 flywheel.

gee2er

Posted 8/7/2016 6:34 PM (#722366 - in reply to #722349)
Subject: RE: fly wheel

Veteran

Posts: 435
100

Location: birmingham drives purple R100

thanks for that mate a good mate off here told me it would be ok then some ppl told me it would not work so just wanted to be 100% befor I fit the engine and find out it wont run

Dave 20VTRO

Posted 8/7/2016 7:10 PM (#722367 - in reply to #722366)
Subject: RE: fly wheel

Elite Veteran

Posts: 925
500

Location: Thinking of vvc'ing my Roadster Brabus :-)

gee2er - 9/7/2016 5:34 PM

thanks for that mate a good mate off here told me it would be ok then some ppl told me it would not work so just wanted to be 100% befor I fit the engine and find out it wont run

Just make sure the pattern is the same, and that it isn't a cvt flywheel, ie it should be the same outer dia (starter ring dia) as
the 1.1 flywheel. A cvt flywheel is bigger dia, plus the drive plate setup is different.

Jump to page : 1
Now viewing page 1 [25 messages per page]

Printer friendly version
E-mail a link to this thread
Jump to forum :

(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software