Viewing a thread

You are logged in as a guest. ( logon | register )

160vvc vacuum hoses Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page]
Technical Area-> Technical	Message format

matty h

Posted 23/2/2016 9:11 PM (#721216)
Subject: 160vvc vacuum hoses

Regular

Posts: 206
100

I am fitting a 160vvc mems3 engine and would like to know where the pipes go on the inlet manifold photo if possible.
There is a connection on the fuel pressure regulator, two on the end of the inlet manifold next to the map sensor and one just after the throttle body can someone help me and tell me or show me what goes on all these.
Thanks Matty

R100_vvc

Posted 23/2/2016 9:54 PM (#721217 - in reply to #721216)
Subject: RE: 160vvc vacuum hoses

Expert

Posts: 2029
2000

Location: sittingbourne, kent

the 2 left other then fitting one to the fuel regulator are normally blanked in a metro, unless you still want to use the carbon canister which will use one? otherwise blank off the remaining 2

Edited by R100_vvc 23/2/2016 9:56 PM

Jump to page : 1
Now viewing page 1 [25 messages per page]

Printer friendly version
E-mail a link to this thread
Jump to forum :

(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software