Viewing a thread

You are logged in as a guest. ( logon | register )

Haynes wiring diagram mistake? Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page]
Technical Area-> Technical	Message format

Re-Carbed

Posted 31/3/2016 9:47 PM (#721682)
Subject: Haynes wiring diagram mistake?

Member

Posts: 67

My 1993 1.1 Metro has a carb and the wiring diagram is "Diagram 1". The issue is the wiring to the manifold heater switch item 78. Surely one end of this switch should be earthed? not connected to the starter solenoid-started switch feed as shown? Looks like that brown/red wire and connector block are a mistake. What do you think? Haynes 1711.

MetroGaz

Posted 1/4/2016 9:58 AM (#721686 - in reply to #721682)
Subject: RE: Haynes wiring diagram mistake?

Veteran

Posts: 335
100

Location: York, tis Cold Up North!

Hi

Item 78 does have an earth.

It takes it's feed from 92(Starter Relay) and then goes through the realy coil in 77(Manifold Heater Relay) and then goes to Earth via the white wire on other side of coil to the earth (-ve) point.

So to me it is all correctly shown.

MG

Jump to page : 1
Now viewing page 1 [25 messages per page]

Printer friendly version
E-mail a link to this thread
Jump to forum :

(Delete all cookies set by this site)
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software