Metropower Portal | ||
| ||
What's the lowest? Moderators: Jump to page : 1 Now viewing page 1 [25 messages per page] | |
Technical Area-> Styling | Message format |
Miller |
| ||
ADMIN Posts: 2366 Location: Chesterfield ish kinda sort of | What's the lowest you guys have lowered your Metros (safely, Not letting the fluid out) and driven around without changing your mind and making it higher again? | ||
OrangeManDan |
| ||
Border Crosser Posts: 3232 Location: Carmarthenshire, Wales | I have lowered mine 30mm front and 60mm back but I want to go lower. Not sure what psi I am running though. | ||
ding |
| ||
Dan yours handles like a boat compared to mine, it's all over the place. Get sea sick in the thing. Cut 10mil all round and have the front at 425 psi and the rear at 400. Mine handles mint, and isn't to low to be touching cats eye's, but low enough | |||
Marv_666 |
| ||
'88 MG METRO 1300 Posts: 1117 Location: Dudley, Midlands | If you're wanting to throw your own car in the weeds Miller... consider clearance from tarmac to sumpy/gearboxey type thing... got an idea the auto is deeper!? (not sure if that's right though!) Only real limits are budget, and how bad a ride you can tolerate!? Assume you don't want to go mental with mods?? | ||
Miller |
| ||
ADMIN Posts: 2366 Location: Chesterfield ish kinda sort of | nah, I aint lowering my Auto, just wondered what people had done | ||
munday |
| ||
Expert Posts: 5629 Location: Letchworth/Basildon | And getting on my drive... Rolled like that daily | ||
Paul_T |
| ||
'Metropower's James May' Posts: 2977 Location: Southport, North West | Ran like that for a while as I only went round town and never near speed bumps! | ||
pickford |
| ||
Extreme Veteran Posts: 586 Location: brighouse just shy huddersfield | Cj how much did you take off the rods to get it that low I'd love to go That low and I presume that's on 155s? | ||
metrobruce |
| ||
Elite Veteran Posts: 763 | pickford - 10/7/2013 12:06 AM Cj how much did you take off the rods to get it that low I'd love to go That low and I presume that's on 155s? from what they look like they are 175/50/13 tyres on cj's car and if you want to go that low i cut 13mm of the front of mine and 18mm off the rear | ||
Paul_T |
| ||
'Metropower's James May' Posts: 2977 Location: Southport, North West | 175/50/13 tyres and the rods were all on the piss so I had different pressures in them to keep it level. | ||
Paul r |
| ||
Extreme Veteran Posts: 539 Location: Swindon, Wilts | Mine, goes over speed bumps but not cans Edited by Paul r 13/7/2013 3:43 PM | ||
Jump to page : 1 Now viewing page 1 [25 messages per page] |
Printer friendly version E-mail a link to this thread Jump to forum : |
(Delete all cookies set by this site) | |
Running MegaBBS ASP Forum Software v2.0 © 2003 PD9 Software | |