Be easier and cheaper to source a 160. Don't think you could convert the lump to run on mems3. ZR 160's are going cheap as fook, I've seen some go for 200-300 quid. Take the engine ecu and loom, selector rods and sell on the rear beam/rear disc conversion for 1.4's etc and front brake set up etc to get some cash back. Doesn't have to be a TF, although with one you'd have the subframe and shafts if you fit the shite PG1, but those are cheap anyway. Worse bit is converting the loom but theres a couple on that facebook shite that could do it for you. |